Basic Operation; Amp Operation - Marantz SR5004 User Manual

ENGLISH

BASIC OPERATION

AMP OPERATION

The unit shown in the illustrations is SR6004.
TURNING ON THE UNIT
1.
Turn the power of the equipment connected
to this unit on.
2.
Press the POWER ON/STANDBY button of
this unit. Every time the button is pressed,
the power to this unit toggles between on
and standby.
To activate power using the remote
controller, press the AMP button, followed
by the ON button and SOURCE ON/OFF
button of the remote controller.
SELECTING AN INPUT SOURCE
Before you can listen to any input media, you must
fi rst select the input source on the unit.
EXAMPLE : DVD
16
To select DVD, turn the INPUT SELECTOR knob
on the front panel or press the DVD button on the
remote controller two times in a row. After you have
selected DVD, simply turn on the DVD player and
play the DVD.
• As the input source is changed, the new input
name will appear momentarily an OSD information
on the video display. The input name will also
appear in the display, on the front-panel.
• If you use the FUNCTION RENAME feature (see
page 26) , the renamed name appears on the
display.
• As the input is changed, this unit will automatically
switch to the digital input, surround mode,
attenuation, and night mode status which were
entered during the confi guration process for that
source.
• When a video source is selected, the selected
video signal is output from the MONITOR OUT
terminal.
ADJUSTING THE MAIN VOLUME
Adjust the volume to a comfortable level using
the VOLUME control knob on the front panel or
VOLUME + / – buttons on the remote controller.
To increase the volume, turn the VOLUME knob
clockwise or press VOLUME + button on the
remote controller, to decrease the volume, turn
counterclockwise or press VOLUME – button on
the remote controller.
Notes
• The volume can be adjusted within the range of
– ∞ and –71 to 18 dB, in steps of 1 dB.
• However, when the channel level is set as described
on page 32, if the volume for any channel is set at
+1 dB or greater, the volume cannot be adjusted
up to 18 dB.
(In this case the maximum volume adjustment
range is "18 dB - Maximum value of channel
level)
ADJUSTING THE TONE (BASS & TREBLE)
CONTROL
During a listening session you may wish to adjust
the Bass and Treble Control to suit your listening
tastes or room acoustics.
(Using the remote controller)
To adjust the tone, press the AMP button.
To adjust the bass effect, press BASS + or BASS
– button.
To adjust the treble effect, TREBLE + or TREBLE
– button.
Notes
The tone control function cannot be used in any of
the modes listed below.
• Source Direct
• Pure Direct
• 7.1 ch Input
• Dolby Virtual Speaker
• Dolby Headphone
• Dolby True HD
• Dolby Digital Plus
• DTS-HD and 176.4/192 kHz PCM
• Accoustic EQ
• M-DAX
TEMPORARILY TURNING OFF THE SOUND
To temporarily silence all speaker outputs such as
when interrupted by a phone call, press the MUTE
button on the remote controller.
This will interrupt the output to all speakers and the
head-phone jack, but it will not affect any recording
or dubbing that may be in progress.
When the system is muted, the display will show
"MUTE" .
Press the MUTE button again to return to normal
operation.