Remote Controller Rc1400; Names And Functions - Marantz SR7400 User Manual

!8
AUDIO IN/OUT (CD, TAPE, CD-R, TV,
DVD, VCR1, DSS/VCR2)
These are the analog audio inputs and outputs. There
are 7 audio inputs (4 of which are linked to video
inputs) and 4 audio outputs (2 of which are linked to
video outputs). The audio jacks are nominally labeled
for cassette tape decks, compact disc players, DVD
players and etc.... The audio inputs and outputs
require RCA-type connectors.
!9
DIGITAL INPUT (Dig.1 - 6) / OUTPUT
(coaxial, optical)
These are the digital audio inputs and outputs.
There are 3 digital inputs with coaxial jacks, 3 with
optical jacks.
The inputs accept digital audio signals from a
compact disc, LD, DVD, or other digital source
component.
For digital output, there is 1 coaxial output and 1
optical output.
The digital outputs can be connected to MD
recorders, CD recorders, DAT decks, or other
similar components.
REMOTE CONTROLLER
RC1400

NAMES AND FUNCTIONS

z
POWER
x
OFF ON/OFF ON
SOURCE
M
D1
D2
¤1
D3
D4
D5 D5
¤0
CH VOL
⁄9
OK
⁄8
PREV MUTE
GUIDE
MENU EXIT
⁄7
TEST CH.SEL SURR
1 2 3
7.1CH ATT SPK-AB
4 5 6
DISP OSD SLEEP
7 8 9
⁄6
0
CLEAR MEMO
TV DVD VCR DSS
TUNER CD CD-R MD
TAPE AUX1 AUX2 AMP
LIGHT
1 2
RC1400
Learning Remote Controller
z Infrared Transmitter and Learning
Sensor
This transmitter emits infrared light. Press the
buttons while pointing the transmitter towards the
infrared receiver window of the SR7400 or other
AV equipment. Be sure to also point towards other
remote controls when using the learning function.
x POWER ON and OFF buttons
(When AMP mode is selected)
These buttons are used to turn the SR7400 on or
off.
c SOURCE ON/OFF button
This button is used to turn a specific source (such
c
as a DVD player) on or off independently from the
rest of the system.
v
v M (Mode) button
b
This button is used to program Macros. Pressing
this button switches between Normal mode and
Macro mode.
The > button is used to move to the next page. Up
n to 20 programs (4 pages) can be made. Holding
down the M button for three seconds or more
switches to the Setup mode, where the Setup
menu is shown on the LCD. The Setup menu has
four pages, and the > button is used to move to the
next page. Pressing the > button from page 4
m
returns you to page 1.
,
b D1 to D5 (Direct) buttons
Five types of direct operations can be performed
.
for each of the 12 source buttons such as the DVD,
television, amplifier, and other AV equipment. The
⁄0
pages can be switched, so 4 pages x 5 types = 20
operations can be performed for a single source.
⁄1
The text display can also be changed.
⁄2
n > (Page) button
This button is used to switch pages for the Direct
button. The current page is shown on the LCD.
⁄3
m VOL (Volume) button
This button is used to adjust the volume for the
⁄4
amplifier and television.
Note:
⁄5
• Set the AMP mode to use this button with the
SR7400.
7