Intermec EasyCoder PD4 User Manual page 58

Chapter 7—Troubleshooting
Printout not in desired position
When printing, page skipping occurs
Weak printout
Uneven darkness across media path
When using cutter, label was not cut
straight
When using cutter, label was not cut suc-
cessfully
When using cutter, label could not feed or
abnormal cutting occurs
When using stripper, abnormal function
occurs
Note: If further problems should occur, please contact your distributor for
more information.
48
Check for bad settings in the application
or ESim command errors
Check if label gap sensor is disturbed
by media, dust, or erroneously loaded
transfer ribbon
Check lateral position of label gap sensor
Calibrate label gap sensor in Autoadjust
Mode
Check the edge guide and media guides
Check the media (too little liner transpar-
ency, weak black marks, or interfering
preprint at the back of the media?)
Check if platen roller needs cleaning or
replacement
Check if label gap sensor is disturbed by
dust or foreign objects
Check density setting
Check if thermal printhead needs cleaning
Check printhead pressure
Check printhead dot line position
Check printhead balance
Check if media is loaded correctly
Check whether media thickness exceeds
0.16 mm (6.3 mils)
Check if media is loaded correctly
Check if cutter is installed properly
Check if paper feed rods are sticky. Clean
if necessary using isopropyl alcohol
Check if stripper full sensor is working
Check if media is loaded properly
Intermec EasyCoder PD4—User's Guide