Self-Adhesive Labels - Intermec EasyCoder PD4 User Manual

Self-Adhesive Labels

⇐ a ⇒ Media Width (including liner)
Maximum:
Minimum:
⇐ b ⇒ Liner
The backing paper must not extend more than a total of 1.6 mm (0.06
inches) outside the labels and should protrude equally on both side.
⇐ c ⇒ Label Width (excluding liner)
Maximum:
Minimum:
⇐ d ⇒ Label Length
Maximum:
8 dots/mm (203.2 dpi)
11.81 dots/mm (300 dpi)
Minimum:
8 dots/mm (203.2 dpi)
11.81 dots/mm (300 dpi)
⇐ e ⇒ Label Gap
Maximum:
Recommended:
Minimum:
The Label gap sensor must be able to detect the extreme front edges of
the labels. It can be moved 0 to 57 mm (0 to 2.24 inches) from the inner
edge of the media (see Chapter 9).
Paper Type Setup
• Gap paper
Intermec EasyCoder PD4—User's Guide
Appendix B—Media Specifications
118.0 mm (4.65 inches)
25.0 mm (1.00 inches)
116.4 mm (4.58 inches)
23.8 mm (0.94 inches)
1270 mm (50 inches)
558.8 mm (22 inches)
5 mm (0.2) inches)
5 mm (0.2 inches)
26.0 mm (1.02 inches)
3.0 mm (0.12 inches)
1.2 mm (0.05 inches)
77