Clearing Media Jam In Cutter - Intermec EasyCoder PD4 User Manual

Clearing Media Jam in Cutter

To clear a media jam inside the cutter mechanism, follow the instructions
below:
1 At media jams and cutter malfunctions, switch off the power to the
printer.
Never insert fingers or tools into the printer while the
power is still on.
2 Insert a 3 mm hexagon screwdriver in the hole on the side of the
cutter (A) and turn the cutter blade clockwise.
3 After the media jam is cleared, switch on the power to the printer, and
the cutter blade will go back to its original position.
Note: It is recommended to use labels with a length of 30 mm
(1.18 in) or more.
Intermec EasyCoder PD4—User's Guide
Chapter 7—Troubleshooting
A
49