Self-Adhesive Labels - Intermec EasyCoder F2 Installation & Operation Manual

Appendix 2 Media Specifi cations
Media, cont.

Self-Adhesive Labels

a
c
d
SELF-ADHESIVE
LABELS
b
FEED
DIRECTION
68
a Media Width (including liner):
Maximum:
Minimum (standard):
Minimum (Quick-Load):
b Liner
The backing paper must not extend more than a total of 1.6 mm (0.06
inches) outside the labels and should protrude equally on both side.
Recommended min. transparency: 40% (DIN 53147).
c Label Width (excluding liner):
Maximum:
Minimum:
d Label Length:
Maximum:
Minimum:
Under ideal circumstances, a minimum label length of 4 mm (0.16
e
inches) could be used. It requires the sum of the label length (d) and
the label gap (e) to be larger than 7 mm (0.28 inches), that batch
printing is used, and that no pull back of the media is performed.
Intermec does not guarantee that such short labels will work, but it
is up to the user to test this in his unique application.
e Label Gap:
Maximum:
Recommended:
b
Minimum:
The Label Stop Sensor must be able to detect the extreme front
edges of the labels. It can be moved between 5 fi xed positions at the
following distances from the inner edge of the media.
3 mm
8 mm
12 mm
16 mm
20 mm
Media Type Setup:
• Gap
Intermec EasyCoder F2 – Installation & Operation IPL Version, Ed. 1
60.0 mm
25.0 mm
40.0 mm
58.4 mm
23.8 mm
depends on DRAM size
21.3 mm
(0.118 inches)
(0.315 inches)
(0.472 inches)
(0.639 inches)
(0.787 inches)
(2.36 inches)
(1.00 inches)
(1.57 inches)
(2.30 inches)
(0.94 inches)
8.0 mm (0.32 inches)
(0.83 inches)
3.0 mm (0.12 inches)
1.2 mm (0.05 inches)