Clearing Media Jams - Intermec PD41 Manual

Chapter 4 — Troubleshooting and Maintaining the Printer

Clearing Media Jams

78
To adjust the ribbon shield
1 If the label printout matches:
• Test Label A, turn screw A clockwise.
• Test Label B, turn screw B clockwise.
2 Twist the screw a half-turn and perform a new test print.
3 Continue adjusting the ribbon shield screws until you achieve
good printout quality.
Note: Do not exceed two full turns of a ribbon shield screw or the
media may not feed smoothly. If this situation happens, turn the
screws counterclockwise completely and start over.
Common causes of media jams include media not being loaded
properly or the printer not being maintained properly.
To clear a media jam
1 Turn off the printer.
PD41 and PD42 Commercial Printer User's Manual
B
A