Using The Cutter; Routing Media Through The Heavy-Duty Cutter - Intermec 4630 User Manual

Roller
bracket

Using the Cutter

You can order the heavy-duty cutter option for the 4630 and 4830 printers or
you can purchase the standard cutter option that is only available for the 4630
printer. The heavy-duty cutter is designed to cut adhesive-backed media and
tag media whereas the 4630 standard cutters should only cut media backing.

Routing Media Through the Heavy-Duty Cutter

1. Turn off the printer and remove the
2. Open the stock door.
3. Open the heavy-duty cutter assembly.
4. Load the printer with media and route
5. Feed the media through the cutter
6. Close the heavy-duty cutter assembly until the latch engages.
Media path
Release tab
AC power cord.
the media through the printer until
about 2 inches (5 cm) of media extend
from the front of the printer.
media guides while closing the heavy-
duty cutter assembly.
Note: Do not allow the media to bunch
between the cutter and the printer.
Operating and Configuring the Printer
Fixed bracket
4630U-44
2
2-19