Front I/O Device
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Disconnect the two front I/O cables from the system board.
6.
Remove the screw that secures the front I/O device to the chassis (1).
7.
Pull the device from the chassis and guide the cables through the hole to remove them from the
chassis (2).
To reinstall the front I/O device, reverse the removal procedure.
148 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
(Front Bezel on page
114).
107).
113).