2.
Gently push the subpanel out the back of the front bezel (1).
Figure 4-12
3.
Remove the desired bezel blank by applying outward pressure on the subpanel (1) and pulling the
blank away (2).
NOTE:
The bezel blanks are keyed to assist you in replacing them. Also, the subpanel can be rotated
90 degrees to install optical drives in a desktop orientation.
Front panel I/O device assembly
This section describes how to remove and install a front panel I/O device assembly.
Removing the front panel I/O device assembly
To remove the front panel I/O device assembly:
1.
Disconnect power from the system
access panel
(Removing the front bezel on page
ENWW
Removing the bezel blanks
(Predisassembly procedures on page
(Removing the side access panel on page
68).
58), remove the side
64), and then remove the front bezel
Removing and replacing components
69