Front Panel I/O Device Assembly - HP xw4550 Service And Technical Reference Manual

4. Slide the solenoid hood lock assembly (3) away from the chassis and out of the workstation.
Figure 4-9
To install the hood lock, reverse the previous steps.

Front panel I/O device assembly

To remove the front panel I/O device assembly:
1. Disconnect power from the system
access panel
on page
2. Unlatch the plastic snap that secures the cables inside the chassis and disconnect the front panel
I/O device assembly cables from the system board.
3. Remove the two smaller Torx screws (1) that hold the front panel I/O device assembly (3) and
bracket to the chassis.
4. Remove the two larger Torx screws (2) that hold the front panel I/O device assembly (3) to the
bracket.
5. Separate the bracket away from the front panel I/O device assembly.
6. Pull the front panel I/O device assembly out about two inches away (4) from the chassis.
66 Chapter 4 Removal and replacement procedures
Removing the hood lock
(Side access panel on page
63).
(Predisassembly procedures on page
62), and remove the front bezel
57), remove the side
(Front Bezel
ENWW