Removal And Replacement Procedures Convertible Minitower (Cmt) Chassis; Preparation For Disassembly - HP Compaq dc7800 Reference Manual

7 Removal and Replacement Procedures
Convertible Minitower (CMT) Chassis
Adherence to the procedures and precautions described in this chapter is essential for proper service.
After completing all necessary removal and replacement procedures, run the Diagnostics utility to verify
that all components operate properly.
NOTE: Not all features listed in this guide are available on all computers.

Preparation for Disassembly

See Identifying the Chassis, Routine Care, and Disassembly Preparation on page 51
procedures.
1. Remove/disengage any security devices that prohibit opening the computer
Cover Lock on page 61
2. Close any open software applications.
3. Exit the operating system.
4. Remove any diskette, compact disc, or media card from the computer.
5. Turn off the computer and any peripheral devices that are connected to it.
CAUTION:
Regardless of the power-on state, voltage is always present on the system board as long as the
system is plugged into an active AC outlet. In some systems the cooling fan is on even when the
computer is in the "Standby," or "Suspend" modes. The power cord should always be disconnected
before servicing a unit.
6. Disconnect the power cord from the electrical outlet and then from the computer.
7. Disconnect all peripheral device cables from the computer.
8. Lay the computer down on its side to achieve a safe working position.
NOTE:
Keep all screws with the units removed.
CAUTION:
screw in an application may damage the unit.
60 Chapter 7 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis
and External Security Devices on page
Turn off the computer before disconnecting any cables.
During disassembly, label each cable as you remove it, noting its position and routing.
The screws used in the computer are of different thread sizes and lengths; using the wrong
for initial safety
(Unlocking the Smart
62).