Vise - Grizzly G0665 Owner's Manual

vise

Adjustable vise Jaw
the vise jaw on the Model g0665 can be adjusted
for maximum support while still providing clear-
ance at a variety of cutting angles. the Model
g0665 also features an auxiliary stability bracket
for additional support during cutting procedures.
Tools Needed:
hex Wrench 10mm ............................................ 1
NOTICE
Prior to cutting, both the jaw and stability
bracket must be checked for blade clear-
ance. failure to do this could cause the
blade to contact the vise during the cut,
resulting in damage to the machine.
Vise Jaw
figure 19. Adjustable vise jaw.
To adjust the vise jaw:
1.
disConneCt sAW FroM poWer!
2. set the cutting angle, as described in Cutting
Angle on Page 17.
3.
lower the saw to check for clearance.
—if the saw blade lowers completely without
touching the vise jaw or stability bracket,
no adjustments are necessary.
-18-
Qty
stability Bracket
—if the saw blade hits the vise jaw, perform
Steps 4–7 on this page.
—if the saw blade hits the auxiliary stability
bracket, see Auxiliary Stability bracket
on Page 19.
4.
loosen the cap screw until the jaw slides
freely (figure 20).
Cap screw
Vise Jaw
figure 20. sliding jaw.
5.
slide the jaw so that it is approximately ½"
away from the blade (figure 21).
Note: At certain angle settings, it may not be
possible to set the jaw within the specifica-
tions described above. If this is the case,
adjust the jaw as far as it can go while still
being securely clamped.
Jaw
figure 21. setting blade clearance.
6.
tighten the cap screw.
7. return to Step 3 and re-check for clearance.
g0665 slow speed Cold Cut saw
⁄ " gap
1
2
Blade