Table of Contents
Advertisement
Cutting Procedures
After familiarizing yourself with the controls of the
Model g0665, follow the basic outline below to
perform safe and efficient cuts.
To make a cut:
1.
disConneCt sAW FroM poWer!
2.
set the cutting angle (Page 17).
3.
Check the blade clearance (Page 18).
4.
set the work stop if required for the task
being performed (Page 20).
5.
Clamp the workpiece (Page 18).
6.
Check the cutting fluid reservoir level.
7.
Make sure the saw is in the fully upright posi-
tion.
8.
Connect the saw to power.
9.
press the trigger switch to start the blade and
cutting fluid pump. once the cutting fluid is
observed on the blade, lower the saw into the
workpiece. use a controlled, steady force to
complete the cut. When the cut is completed,
raise the saw, release the trigger, and allow
the blade to come to a complete stop before
proceeding.
g0665 slow speed Cold Cut saw
Cutting Tips
•
replace, sharpen, and clean blades as nec-
essary to maintain optimum cutting perfor-
mance.
•
use even pressure while cutting. heavy or
irregular pressure can lead to poor cuts and
damage the blade.
•
Misusing the saw or using incorrect tech-
niques is unsafe and results in poor cuts.
remember—the blade does the cutting with
the operator's guidance.
General Machine
Tips
•
When the machine is not in use, raise the
saw to reduce strain on the return spring.
•
inspect the machine regularly to keep it run-
ning in top condition.
•
Clean, lubricate, and cover the machine
before putting it into storage for extended
periods of time.
-23-
Advertisement
Table of Contents
