Vise - Grizzly G0561 Owner's Manual

Vise

The vise can hold material up to six inches wide
and be set to cut angles from 0 to 45 degrees.
To square blade to vise:
1. Loosen lock nut shown in Figure 27 with
wrench or socket.
Figure 27. Location of lock nut.
2. Use scale as a guide to set your angle, or a
machinist's square to square blade to vise.
3. Tighten lock nut.
-24-
To adjust angle on vise:
1.
⁄ "
3
4
2.
Lock Nut
3.
4.
5.
Loosen lock nut on rear jaw with a
wrench, as shown in Figure 28.
Lock Nut
Scale
Figure 28. Location of scale.
Use scale to set your angle.
Tighten lock nut.
Loosen lock nut in Figure 29 on opposite
jaw so jaw can float, and match angle of
workpiece.
Lock Nut
Figure 29. Vise jaw lock nut.
Tighten vise against workpiece.
Model G0561 (Mfd. Since 01/08)
⁄ " hex
3
4