Using Vise - Grizzly G0561 Owner's Manual

Using Vise

The vise can hold material up to 12 inches wide
and be set to cut angles from 0 to 45 degrees.
Tool Needed
Wrench or Socket ⁄ " ........................................ 1
3
4
To use vise:
1. Loosen angle hex nut on rear jaw shown in
Figure 43.
2. Use scale to set angle of rear jaw (see
Figure 43).
— If desired angle can be reached with rear
vise jaw in current position, tighten angle
hex nut to secure. Proceed to Step 7.
— If desired angle cannot be reached with
rear vise jaw in current position, proceed
to Step 3.
Hex Nut
Scale
Figure 43. Location of rear jaw adjustment
components.
3. Remove angle hex nut, flat washer, and car-
riage bolt.
4. Remove pivot bolt and flat washer shown in
Figure 44.
5. Move rear vise jaw so pivot bolt and flat
washer can secure it through alternate pivot
hole (see Figure 44).
-32-
Qty
Rear Jaw
Angle
Alternate
Pivot Hole
Figure 44. Location of pivot bolt and alternate
pivot hole.
6. Use scale to set angle of rear jaw, then secure
with carriage bolt, flat washer, and angle hex
nut removed in Step 3 (see Figure 45).
Figure 45. Rear jaw positioned in alternate
location.
7. Loosen knob bolt in Figure 46 on opposite
jaw so jaw can float, and match angle of
workpiece.
Knob Bolt
Figure 46. Vise jaw knob bolt.
Model G0561 (Mfd. Since 01/18)
Pivot Bolt
& Flat Washer