Setup - Grizzly G0665 Owner's Manual

Setup

setup consists of assembling the stand, mounting
the machine to the stand, and attaching the work
stop.
To assemble the machine:
1. Attach the front panel to one of the side
panels with three M8-1.25 x 20 hex bolts and
nuts, as shown in figure 9.
side panel
figure 9. Front and side panels.
2.
Attach the remaining side panel in the same
manner as Step 1, as shown in figure 10.
figure 10. second side panel attached.
-14-
3.
4.
Front panel
side panel
Attach the rear panel to the stand with the
remaining hex bolts and nuts.
Note: If you plan to mount your machine
stand to the floor, do so now (see Mounting
to Shop Floor on Page 13), then return
to Step 4, below, to mount the machine to
the stand. Otherwise, continue with Step 4,
below.
This machine is very
heavy. Get lifting help or
use power lifting equip-
ment such as a forklift to
place this machine onto
its stand.
place the saw onto the stand and secure it
with the four M8-1.25 X 35 hex bolts (figure
11).
hex Bolt
figure 11. Mounting saw onto stand.
g0665 slow speed Cold Cut saw
saw Base
stand