Grizzly G0665 Owner's Manual page 36

Main hinge Pin
1.
disConneCt sAW FroM poWer!
2.
lower the saw.
3. use an oil can to apply several drops of sAe
30Wt oil into the hole in the back of the hinge
pin housing (figure 38).
oil hole
figure 38. oil change.
4.
Wait several minutes for the oil to spread,
then raise and lower the saw repeatedly to
distribute the oil.
5. Wipe any excess oil from the machine.
-26-
Gearbox Oil
With regular use, the oil in the gearbox must be
drained and replaced every six months.
Tools Needed
Wrench ⁄ " ......................................................... 1
7
8
drain pan .......................................................... 1
Funnel ................................................................ 1
To change the gearbox oil:
1.
disConneCt sAW FroM poWer!
2.
raise the saw to the up-most position.
3. remove the oil fill/drain plug (figure 39).
oil Fill/drain plug
figure 39. hinge pin lubrication.
4.
hold the drain pan under the oil fill/drain
plug, then tilt the saw forward and allow all of
the oil to drain out.
5. raise the saw back to the up-most position.
6. refill the gearbox with standard automotive
85w-140 gear oil until only a small air bubble
remains in the sightglass.
7.
replace the fill/drain plug.
g0665 slow speed Cold Cut saw
Qty
sightglass