Work Stop - Grizzly G0665 Owner's Manual

5.
rotate the quick release lever counterclock-
wise to clamp the workpiece. Between cuts,
rotate the lever clockwise to release the
workpiece, then counterclockwise again to
reclamp it (figure 25).
released
Clamped
figure 25. Quick release lever positions.
Note: An alternative method for using the
quick release lever is to rotate the lever
downward prior to clamping the workpiece.
With the lever in this position, fully clamp
the workpiece using the vise handwheel.
To release the workpiece, rotate the lever
clockwise to the up position. The method you
practice is a matter of personal preference.

Work Stop

use the work stop to perform consistent length
cuts.
Tools Needed:
hex Wrench 5mm .............................................. 1
To use the work stop:
1. disConneCt sAW FroM poWer!
2. loosen the work stop cap screw (figure 26).
-20-
figure 26. Work stop adjustment.
3.
lower the blade as far as it will go.
4.
Measure from the side of the blade to the
work stop. slide the work stop until the dis-
tance between the blade and the work stop is
equal to the desired length of the piece being
cut, then tighten the cap screw (figure 27).
figure 27. Measuring length of cut.
Qty
5.
Before making a cut, slide the stock until it is
against the work stop. Clamp the workpiece
in the vise, then proceed with the cut. repeat
this process before each new cut for consis-
tent length cuts.
Work stop
Cap screw
Blade
tape Measure
Work stop
g0665 slow speed Cold Cut saw