Inventory - Grizzly G0665 Owner's Manual

inventory

A
the following is a description of the main compo-
nents shipped with your machine. lay the compo-
nents out to inventory them.
Note: If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
B
C
Container 1: (figure 3) Qty
figure 3. Machine inventory.
A. saw............................................................. 1
b. Work stop rod ........................................... 1
C. Work stop ................................................... 1
Container 2: (figure 4)
D. stand rear panel ....................................... 1
d
E. stand side panels ...................................... 2
e
f.
stand Front panel ...................................... 1
hardware: (Not Shown)
hex Bolts M8-1.25 x 20 (stand) ...................... 12
hex nuts M8-1.25 (stand) ............................... 12
F
hex Bolts M8-1.25 x 35 (saw Mounting) ........... 4
if any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
figure 4. stand inventory.
for the sake of expediency, replacements can be
obtained at your local hardware store.
-11-
g0665 slow speed Cold Cut saw