Vise - Grizzly G0811 Owner's Manual

Vise

Always turn saw OFF and allow blade to
come to complete stop before adjusting
vise! Failure to follow this caution may lead
to injury.
The movable vise (see Figure 40) has a quick
release feature that allows jaw width to be quickly
adjusted when changing from one sized material
to another.
The fixed vise (see Figure 40) can be adjusted to
cut any angle, from a straight 90-degree cut-off to
a 45-degree angle, by loosening the front lock bolt
and rear vise lock handle. Positive stops at 90°
and 45° allow you to quickly return the fixed jaw to
either angle. Angles between 90° and 45° can be
read using the scale on the side of the vise table.
Use a combination square or bevel protractor if
higher precision is required when finding these
angles.
Movable Vise
Fixed Vise
Lock
Scale
Handle
Figure 40. Location of vise components.
Tools Needed
Hex Wrench 3mm .............................................. 1
Hex Wrench 4mm .............................................. 1
Model G0811 (Mfd. Since 02/16)
Vise
Lock
Handwheel
Bolt
Qty
Using Vise
1. Turn vise handwheel (see Figure 40) coun-
terclockwise to relieve any pressure on mov-
able vise jaw.
2.
Pull or push movable vise jaw in desired
direction.
3.
Finish tightening jaw against workpiece with
handwheel.
Note: Figure 41 shows correct methods of
holding different workpiece shapes.
NOT
RECOMMENDED
Figure 41. Example of work holding options by
material shape.
RECOMMENDED
-33-