Test Run - Grizzly G0665 Owner's Manual

5.
Attach the work stop rod by threading it into
the hole in the side of the vise base, as
shown in figure 12.
Vise Base
figure 12. Work stop rod.
6.
slide the work stop onto the work stop rod
and secure it by tightening the cap screw
(figure 13).
Work stop
Cap screw
figure 13. Work stop secured.
7. Verify that there is oil in the gearbox by tilting
the saw up and checking the sightglass.
—if no oil is seen in the sightglass, see
Gearbox Oil on Page 26.
—if oil is seen in the sightglass, no further
action is required. Continue to Test Run.
g0665 slow speed Cold Cut saw
Work stop rod

Test Run

once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 27.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2.
Verify that there is oil in the machine. see
Step 7 of Setup on this page.
3. Make sure all tools and objects used during
setup are cleared away from the machine.
4. Connect the machine to the power source.
5. turn the machine ON.
6.
listen to and watch for abnormal noises or
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
7. turn the machine OFF.
-15-