DataCard RP90 User Manual page 44

Menu Display Settings
Ink Ink Type
Black level
Black mode
SP - Ink1 Level
SP - Ink2 Level
Retransfer Media type:
Temp Level
Speed (front)
Speed (back)
MG Print (JIS)
Standby Front Wait
Back Wait
Buzzer ON or OFF
Power Saving OFF or up to 60 minutes
Bend Remedy Temp Level
Speed
Cooling time
38
YMCK: 0
YMCKPO: 2
YMCKK: 4
750
1000
Function
Displays the type of ink ribbon that is loaded in the printer.
Datacard supports YMCK and YMCKK ink ribbons. (The printer
detects the type of ink ribbon; it cannot be set.) See your dealer
regarding support for YMCKPO ink ribbon.
Choose from seven gradations from -3 (lighter) to +5 (darker).
Choose Standard or Fine. Change to Fine if thin lines or small
black text is blurred (printing speed is slower).
Use SP - Ink1 and Ink2 levels to set the darkness level of
special inks that will be available in the future.
See SP -Ink1 Level above.
Datacard retransfer ribbon is available in 1000 frames per roll.
Set the retransfer roller temperature. Set from -3 (lower) to +2
(higher).
Set the retransfer speed for the front of the card. Set from -10
(slower) to +2 (faster). Initialize the retransfer film after making
"Initialize the retransfer film" on page 17
changes. See
Set the retransfer speed for the back of the card. Set from -10
(slower) to +2 (faster). Initialize the retransfer film after making
"Initialize the retransfer film" on page 17
changes. See
Select ON or OFF.
When printing both sides of a card and using an optional
smart card (IC) unit, specifies whether to wait after the front
side or the back side of the card.
Use to turn the electronic beep sound ON or OFF. The sound
can indicate an error, when fewer than 20 cards remain in the
card hopper, or to confirm a menu selection.
The printer enters power save mode after a specified period
of inactivity. Choose from OFF or select from 5 to 60 minutes
in 5 to15 minute increments. "Sleeping" appears on the LCD
display. To cancel power save mode, press RESET and then
the ENTER key. The printer uses one set of supplies.
Choose from -5 (lower) to 0 (higher) or OFF to set the bend
remedy roller temperature. See
for more information.
Choose from -2 (slower) to +2 (faster) to set the bend remedy
"Bend remedy" on page 56
speed. See
information.
Set the cooling time from 0 (None) to 15 seconds.
RP90 Plus E and RL90 User Guide
Using the LCD menus
"Bend remedy" on page 56
for more
.
.