DataCard RP90 User Manual page 72

LCD Message
HR Cam
Heater Err
HR Overheat
Temp Sensor
Memory Err
Set Temp Err
R. Encoder Err
Overheat
PRT. Communicate
Film Exchanged?
66
Possible Cause
Heater Cam error.
The heater temperature
does not increase.
Heat roller temperature is
too high.
The heat roller
temperature sensor is not
working.
There is an internal
memory error.
There is an error with the
heat temperature setting.
Rotary encoder error.
The temperature inside the
unit is too high.
Communication error with
the printer.
The patch or topcoat
material was changed
while the laminator was
turned off.
Solution
Turn the power switch off, and then back on. Contact
your service provider if this does not correct the
condition.
Check that the voltage inlet switch, located on the
back of the laminator, is in the proper position for the
input voltage. Contact your service provider if this
does not correct the condition.
Turn the unit off and contact your service provider
before powering back on.
Turn the unit off and contact your service provider
before powering back on.
Turn the unit off and contact your service provider
before powering back on.
Turn the unit off and contact your service provider
before powering back on.
Turn the unit off and contact your service provider
before powering back on.
Turn the unit off and contact your service provider
before powering back on.
Check that the laminator cable is connected securely
to the printer.
Turn the printer and laminator off, and then back on to
recycle the power.
Press the RESET/ and then the ENTER key to
initialize the patch or topcoat material.