Power On The Laminator; Lcd Sequence On Laminator Startup - DataCard RP90 User Manual

Power on the laminator

Tips for laminator power
• When connected to a
printer, laminator
messages will not be
displayed until the
printer is powered on.
• Wait while the laminator
initializes.
Follow the guidelines for
•
your organization about
when to power the
laminator on and off.
Check that the red
•
INLET switch, located
on the back of the
laminator, is set for your
input voltage.

LCD sequence on laminator startup

14
When the optional RL90 laminator is
installed, turn the laminator power on
before powering on the printer.
Press the "|" symbol on the
1
laminator power switch.
The laminator powers on. The
2
LCD panel displays
"Initializing" and the green
Ready light blinks.
"Preheating" is displayed for
3
approximately four minutes
while the heat roller warms to
operating temperature.
The LCD panel shows "Ready" and the Ready light is steady green
4
when the laminator is ready to process cards.
RP90 Plus E and RL90 User Guide
Power on