Media Setting Tab - DataCard RP90 User Manual

Status Monitor

Media Setting tab

The Media Setting tab shows:
Display
252: Invalid TAG Data
253: Defective TAG
254: No TAG
255: Defective R/W
Tips for success
RP90 Plus E and RL90 User Guide
• The type of Ink ribbon in the printer, the lot
number of the ribbon, and the number of panel
sets included in the ribbon. The printer
provides this information and it cannot be
changed. If the printer cannot recognize the
type of ink ribbon, one of the following reasons
is displayed:
Reasons for ink recognition error and the solutions
The data for the ink ribbon is incorrect. Replace the ink ribbon and try again.
The printer did not recognize the print ribbon data. Replace the ink ribbon and
try again.
The printer could not read the print ribbon data. Make sure the ink ribbon has
been loaded correctly. See
The printer is defective. The printer must be repaired.
Settings to view or change the type and thickness of cards being used.
•
— For Material, choose PET-G, PVC, or PET (0.25mm). The values for retransfer
speed and temperature (on the
depending on the selected card type.
— For Thickness, choose:
— Standard for cards 0.76mm (0.030in) thick
— Thin for cards 0.25mm (0.010in) thick
A setting to view or change the type of Retransfer (INTM) film.
•
Make sample cards to verify settings before using cards of a different thickness.
•
Print on one side of thin cards. Do not print on both sides.
•
"Load ink ribbon" on page 9
"Retransfer tab" on page 28
.
) change
29