Connect The Power Source - DataCard CR500 Quick Install Manual

CR500 Instant Issuance System Quick Install Guide
b. Secure the printer to the work
surface (if required).
For detailed specifications
and instructions, refer to the
CR500 Instant Issuance System
Installation and User Guide.
c. Attach the concealed output
stacker to the printer.
2
Printer Base
Spacer
Work Surface
Washer
Bolt

3. Connect the Power Source

a. Connect the power cord to the
print unit (A).
b. Connect the power supply to the
security enclosure (B)
c. Connect the power cord to the
power supply (C).
d. Connect the power cords (D and
E) to the power source.
e. Power on the printer to release
transport mode. The printer will
beep several times. The release
takes approximately 30 seconds.
f. Power off the printer.
O 1
On/Off
CR500 Instant Issuance System