Device Popup Menus - Cisco WS-C2955T-12 Software Manual

Menus and Toolbar

Device Popup Menus

Specific devices in the Topology view display a specific popup menu:
•
•
•
•
•
•
The Device Manager option in these popup menus is available in read-only mode on Catalyst 2900 XL
Note
and Catalyst 3500 XL switches running Release 12.0(5)WC2 and later. It is also available on
Catalyst 2950 switches running Release 12.1(6)EA2 and later and on Catalyst 3550 switch running
Release 12.1(8)EA1 or later. It is not available on the Catalyst 1900 and Catalyst 2820 switches.
To display a device popup menu, click an icon, and right-click.
Table 2-20 Device Popup Menu of a Cluster Icon
Popup Menu Option
Expand cluster
Properties
Table 2-21 Device Popup Menu of a Command-Switch Icon
Popup Menu Option
Collapse cluster
Host Name
Bandwidth Graphs
Properties
1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the
Table 2-22 Device Popup Menu of a Member or Standby Command-Switch Icon
Popup Menu Option
Remove from Cluster
Host Name
Device Manager
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
2-26
Cluster (Table 2-20)
Command switch (Table 2-21)
Member or standby command switch
Candidate switch with an IP address
Candidate switch without an IP address
Neighboring devices (Table
Task
View a cluster-specific topology view.
Display information about the device and port on either end of the link and the
state of the link.
Task
View the neighborhood outside a specific cluster.
1
Change the host name of a switch.
Display graphs that plot the total bandwidth in use by the switch.
Display information about the device and port on either end of the link and the
state of the link.
Modes in CMS" section on page
Task
1
Remove a member from the cluster.
1
Change the host name of a switch.
2
Launch Device Manager for a switch.
(Table 2-22)
(Table 2-23)
(Table 2-24)
2-25)
2-33.
Chapter 2 Getting Started with CMS
"Access
78-6511-08