Lre_Link Messages - Cisco WS-C2955T-12 Software Manual

Appendix A System Messages
Error Message LRE_CPE-3-INVALIDPATCH: CPE on interface [chars] has invalid LRE
firmware.
Explanation
information is inconsistent with the firmware contents.
Recommended Action
Error Message LRE_CPE-3-INVALIDPHY: CPE on interface [chars] has an unsupported
Ethernet PHY.
Explanation
Recommended Action
supported.
Error Message LRE_CPE-3-INVALIDMODE: CPE on interface [chars] is in invalid mode
[chars].
Explanation
number. The model number might imply a MAC mode while the CPE is in PHY mode.
Recommended Action
CPE has the correct LRE firmware and if applicable, that the CPE class identifier is correctly set.
Error Message LRE_CPE-SSNCHANGED: CPE unit on interface [chars] changed.
Explanation
interface was replaced.
Recommended Action

LRE_LINK Messages

This section contains the Long-Reach Ethernet link error messages.
Error Message LRE_LINK-3-UPDOWN: Interface [chars], changed state to [chars]
Explanation
and that no Ethernet traffic is being transferred. This could be the result of reconfiguring the port,
reconfiguring a profile in use by this port, a physical disconnection or reconnection of the LRE
connector on the switch, or by someone disconnecting the CPE LRE cable or cycling its power. It
might also be caused by any substantial interruption of the signal or cabling between the LRE port
and the CPE.
Recommended Action
However, if the LRE link does not go back up within a minute or so, it could mean a physical
disconnection at the switch or CPE or a loss of power to the CPE.
78-6511-08
The LRE firmware header does not have a valid signature, or this firmware header
If the CPE is Cisco-certified, reapply the CPE firmware.
The Ethernet PHY device on this CPE is not supported.
Cisco does not support this CPE device. Replace this CPE with one that is
The CPE is in a mode that is inconsistent with its other characteristics, such as the model
Make sure that the CPE model number is correctly set. Also make sure that the
The CPE system serial number changed. This usually means that the CPE unit on this
No action is required.
This message means that the link between the LRE port and the CPE device has been lost
If someone is reconfiguring the port or the profile in use, ignore this message.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Error Message and Recovery Procedures
A-21