Transfer Chassis To A Mechanical Lifting Device - Cisco Nexus 9808 NX-OS Hardware Installation Manual

Transfer Chassis to a Mechanical Lifting Device

Figure 7: Attach Bottom-Support Rails to a Rack
Note
Step 3
Repeat Steps 1 and 2 to attach the other bottom-support rail to the rack.
Note
What to do next
Mount the chassis into the rack.
Transfer Chassis to a Mechanical Lifting Device
Procedure
Step 1 Place the mechanical lifting device in front of the chassis on the pallet (or on Line Card side) as shown.
Note
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
22
Use at least three screws on each end of each bottom-support rail.
Make sure that the two bottom-support rails are level with one another. If they are not level, adjust
the higher rail down to the level of the lower rail.
Illustrations are for representational purposes only.
Unpack and Install the Chassis