Gbic_1000Baset Messages - Cisco WS-C2955T-12 Software Manual

Appendix A System Messages
Error Message FRANK-3-VLAN_DESC_EXCEEDED: Out of vlan desc!!\n
Explanation
ID.
Recommended Action
Enter the show tech-support command to gather data that might provide information to determine
the nature of the error. If you cannot determine the nature of the error from the error message text or
from the show tech-support output, contact your Cisco technical support representative, and provide
the representative with the gathered information.
Error Message FRANK-6-MODULE_INSERTED: Module in slot [dec] is inserted
Explanation
Recommended Action
Error Message FRANK-6-MODULE_REMOVED: Module in slot [dec] was removed
Explanation
Recommended Action

GBIC_1000BASET Messages

This section contains the 1000BASE-T Cisco Gigabit Interface Converter (GBIC) error messages.
Error Message GBIC_1000BASET-6-GBIC_1000BASET_DEFAULT_CONFIG: 1000-BaseT GBIC
module is detected in [chars]. Speed and duplex will be autonegotiated
Explanation
Recommended Action
Error Message GBIC_1000BASET-6-GBIC_1000BASET_NO_CONFIG_DUPLEX: Configuration
ignored. 1000-BaseT GBIC modules only support autonegotiation on duplex.
Explanation
Recommended Action
Error Message GBIC_1000BASET-6-GBIC_1000BASET_NO_CONFIG_NEGOTIATE: Configuration
ignored. 1000-BaseT GBIC modules only support autonegotiation.
Explanation
Recommended Action
78-6511-08
There are no unused VLAN descriptors left in the VLAN descriptor table for that VLAN
Copy the error message exactly as it appears on the console or in the system log.
A Gigabit Ethernet controller-based module has been hot-inserted in a slot.
No action is required.
The module has been removed from the slot.
No action is required.
1000-BaseT GBIC modules only support autonegotiation on speed and duplex.
No action is required.
1000-BaseT GBIC modules only support autonegotiation on duplex.
No action is required.
1000-BaseT GBIC modules only support autonegotiation.
No action is required.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Error Message and Recovery Procedures
A-15