Capitola Messages; Cdp Messages - Cisco WS-C2955T-12 Software Manual

Appendix A System Messages
Error Message AAAA-3-NOSG: No server-group passed through parser.
Explanation
Recommended Action
Enter the show tech-support command to gather data that might provide information to determine
the nature of the error. If you cannot determine the nature of the error from the error message text or
from the show tech-support output, contact your Cisco technical support representative, and provide
the representative with the gathered information.

CAPITOLA Messages

This section contains the Capitola internal module error messages.
Error Message CAPITOLA_MOD-3-APIBADVALUE:\n[chars]: Bad passed in value [chars] is
[dec].
Explanation
Recommended Action
Enter the show tech-support command to gather data that might provide information to determine
the nature of the error. If you cannot determine the nature of the error from the error message text or
from the show tech-support output, contact your Cisco technical support representative, and provide
the representative with the gathered information.
Error Message CAPITOLA_MOD-3-NULLPTR:\n[chars]: Did not expect NULL pointers.
Explanation
Recommended Action
Enter the show tech-support command to gather data that might provide information to determine
the nature of the error. If you cannot determine the nature of the error from the error message text or
from the show tech-support output, contact your Cisco technical support representative, and provide
the representative with the gathered information.

CDP Messages

This section contains the Cisco Discovery Protocol error messages.
Error Message CDP-4-DUPLEX_MISMATCH: Duplex mismatch discovered on [chars]
([chars]), with [chars] [chars] ([chars]).
Explanation
Recommended Action
78-6511-08
An internal error has occurred.
Copy the error message exactly as it appears on the console or in the system log.
Error in initialization of port monitor subsystem.
Copy the error message exactly as it appears on the console or in the system log.
Derived pointers are NULL and could be from bad derivation values.
Copy the error message exactly as it appears on the console or in the system log.
CDP discovered a mismatch of duplex configuration.
Configure the interfaces to the same duplex (full or half).
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Error Message and Recovery Procedures
A-7