Connecting To An Sfp Module - Cisco 2948G - Catalyst Switch Hardware Installation Manual

Connecting To an SFP Module

Connecting To an SFP Module
Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide
4-12
Figure 4-6 Patch Cord Installation
To equipment
This section describes how to connect to an SFP module. For instructions about
how to install or remove an SFP module, refer to the Cisco Small Form-Factor
Pluggable Modules Installation Notes (not orderable but is available on
Cisco.com) and to the documentation that came with your SFP module.
Table 4-4 lists the SFP modules supported by the Catalyst 2948G-GE-TX switch.
Table 4-4 Supported SFP Modules
SFP Type
Fiber-optic 1000BASE-LX
Fiber-optic 1000BASE-SX
Fiber-optic 1000BASE-ZX
Copper 1000BASE-T
Coarse Wave Division Multiplexing
(CWDM) fiber-optic SFP modules
Chapter 4 Configuring the Gigabit Ethernet Ports
To cable plant
Model Number
GLC-LS-SM=
GLC-SX-MM=
GLC-ZX-SM=
GLC-T=
CWDM-SFP-1470=
CWDM-SFP-1490=
CWDM-SFP-1510=
CWDM-SFP-1530=
CWDM-SFP-1550=
CWDM-SFP-1570=
CWDM-SFP-1590=
CWDM-SFP-1610=
78-6286-05