Table of Contents
Advertisement
TRENDnet User's Guide
Windows Vista
1. Click Start
and then click Control Panel.
2. In the Control Panel window, click on Network and Sharing Center.
3. Under Tasks on the left panel, click on Set up a connection or network.
4. In the window, click on Connect to a workplace and then click Next.
5. In the window, click on Use my Internet Connection (VPN).
6. Next to Internet address, enter the remote router WAN (Internet) IP address and then
click Next.
© Copyright 2012 TRENDnet. All Rights Reserved.
7. Enter the user name and password account information you configured in your router
and check Show characters to verify and Remember this password to save the
credentials. Click Connect.
8. Your computer will attempt to connect to the PPTP VPN server (router).
9. If successful, you will receive a message that indicates you are connected.
10. To verify connectivity, you can use the ping connectivity test. Click Start
at the same time to bring up the run command window. Type cmd in the run command
window and click OK. In the command prompt, type ping <IP address> of remote
computer or device over the VPN. If you receive replies, the connectivity is successful. If
you receive time outs, there may problems with IP configuration or firewall/security
settings of the remote computer or device you are trying to communicate.
TW100-BRV214
+ R key
74
Advertisement
Table of Contents
