Table of Contents
Advertisement
TRENDnet User's Guide
Connecting to your router using the built-in PPTP VPN client software
Note: Below are the examples according to the examples provided in the Virtual Private
Networking PPTP section. Please ensure that your VPN client computer is able to access
the Internet from a remote location.
Windows 7
and then click Control Panel.
1. Click Start
2. In the Control Panel window, click on Network and Sharing Center.
3. Under Change your networking settings, click on Set up a new connection or
network.
4. In the window, click on Connect to a workplace and then click Next.
5. In the window, click on Use my Internet Connection (VPN).
© Copyright 2012 TRENDnet. All Rights Reserved.
6. Next to Internet address, enter the remote router WAN (Internet) IP address and then
click Next.
7. Enter the user name and password account information you configured in your router
and check Show characters to verify and Remember this password to save the
credentials. Click Connect.
8. Your computer will attempt to connect to the PPTP VPN server (router).
9. If successful, you will receive a message that indicates you are connected.
10. To verify connectivity, you can use the ping connectivity test. Click Start
at the same time to bring up the run command window. Type cmd in the run command
window and click OK. In the command prompt, type ping <IP address> of remote
computer or device over the VPN. If you receive replies, the connectivity is successful. If
you receive time outs, there may problems with IP configuration or firewall/security
settings of the remote computer or device you are trying to communicate.
TW100-BRV214
+ R key
73
Advertisement
Table of Contents
