Table of Contents
Advertisement
TRENDnet User's Guide
•
Destination IP : Ports – Enter the destination IP address of the
computer/device located on your local network and port number to apply the
filter. To specify all port numbers, do not specify any value for Ports field. For
specific port numbers, enter a port number or range within the range of 1-
65535 (e.g. 21 or 21-30) in the Ports field.
•
Protocol – Select the protocol type to filter. TCP, UDP, or you can select Both
to choose both protocol types.
•
Enable – Check the option to enable the filter.
•
Use rule# - Click the drop-down list to select a pre-defined schedule. The filter
will only be active during the time period defined in the pre-defined schedule.
Note: Before applying scheduling, please ensure your Time settings are
configured correct and you have defined a schedule. See page 37 to configure
Time Settings and see page 51 to create a schedule.
To save changes, click Save at the bottom of the page.
Note: If you would like to discard the changes, click Undo before you click Save.
Clicking MAC Level will bring you to the MAC Control configuration page. See MAC
Control section.
© Copyright 2012 TRENDnet. All Rights Reserved.
TW100-BRV214
35
Advertisement
Table of Contents
