Table of Contents
Advertisement
TRENDnet User's Guide
3. Review the DHCP Server settings.
•
DHCP Server – Enable or Disable the DHCP server.
•
IP Pool Starting Address – Changes the starting address for the DHCP server
range. (e.g. 192.168.10.20)
•
IP Pool Ending Address – Changes the last address for the DHCP server range.
(e.g. 192.168.10.30)
Note: The Start IP and End IP specify the range of IP addresses to automatically
assign to computers or devices on your network.
•
Lease Time – Enter the lease time in seconds that DHCP client will hold their
automatically assigned IP address before requesting a new IP address.
•
Domain Name (Optional) – Specifies a domain name to assign to computers or
devices. (e.g. trendnet.com)
Note: The DHCP lease time is the amount of time a computer or device can keep an
IP address assigned by the DHCP server. When the lease time expires, the computer
or device will renew the IP address lease with the DHCP server, otherwise, if there is
no attempt to renew the lease, the DHCP server will reallocate the IP address to be
assigned to another computer or device.
4. To save changes, click Save at the bottom of the page.
Note: If you would like to discard the changes, click Undo before you click Save.
© Copyright 2012 TRENDnet. All Rights Reserved.
Note: Clicking the More>> option will allow you to configure additional parameters for
your DHCP server on your router to assign to computers or devices on your network.
Clients List – If you click Clients List, you can view the list of active lease entries for
computers or devices that have been assigned IP addresses automatically from the
DHCP server on your router.
TW100-BRV214
40
Advertisement
Table of Contents
