Table of Contents
Advertisement
TRENDnet User's Guide
11. Next to IPsec Proposal, check the Enable option. Next to ID 1, click the Encryption
drop-down list and select AES-128. Check the Enable option.
Note: The IPsec proposal settings must match the setting configured in VPN Router A.
12. Click Save at the bottom of the page to save the changes.
Note: If you would like to discard the changes, click Undo before you click Save.
To view the status of the IPsec Site-to-Site VPN tunnel, click Back at the bottom of the
page to go back to the main IPsec VPN configuration page.
VPN Router A Tunnel Status
VPN Router B Configuration
© Copyright 2012 TRENDnet. All Rights Reserved.
1. Log into your router management page (see "Access your router management page"
on
page
36).
Note: If you changed router LAN IP address, you will need to log into the remote router
using the new IP address instead of the default 192.168.10.1.
2. Click on Configuration at the top of the page, click on Security Setting, and click on
VPN-IPsec.
3. Next to VPN-IPsec, check the Enable option to enable IPsec.
Note: If Enable is not checked, then this will disable all IPsec functionality on your router.
4. For ID 1, check the Enable option and then click Edit.
5. Next to Tunnel Name, enter the tunnel name in the field. (e.g. Tunnel 1)
6. Enter the network settings for the IPsec Site-to-Site VPN tunnel.
TW100-BRV214
15
Advertisement
Table of Contents
