Table of Contents
Advertisement
TRENDnet User's Guide
5. Next to Dynamic VPN, check the Enable option and click Edit.
6. Next to Tunnel Name, enter the tunnel name in the field. (e.g. Tunnel 1)
7. Enter the network settings for the IPsec VPN Server.
•
Local Subnet – The local LAN IP subnet or network of your local VPN router.
(e.g. 192.168.10.0)
•
Local Netmask – The local LAN subnet mask of your local VPN router.
(e.g. 255.255.255.0)
8. Next to Preshare Key, enter the preshared key for your IPsec tunnel.
Note: The preshared key entered must be the same as the preshared key configured in
VPN Router A.
Note: The preshared key can consist of alphanumeric characters (a,b,C,?,*, /,1,2, etc.)
9. Click the PFS Group drop-down list, and select Same as Phase 1.
10. Next to Dead Peer Detection (DPD), check the Enable option.
© Copyright 2012 TRENDnet. All Rights Reserved.
11. Next to IKE Proposal, check the Enable option. Next to ID 1, click the Encryption
drop-down list and select AES-128 and click the DH Group drop-down list and select
Group 2. Check the Enable option.
12. Next to IPsec Proposal, check the Enable option. Next to ID 1, click the Encryption
drop-down list and select AES-128. Check the Enable option.
13. Click Save at the bottom of the page to save the changes.
Note: If you would like to discard the changes, click Undo before you click Save.
TW100-BRV214
18
Advertisement
Table of Contents
