Table of Contents
Advertisement
TRENDnet User's Guide
1. Log into your router management page (see "Access your router management page"
on
page
36).
2. Click on Configuration at the top of the page, click on Security Setting, and click on
VPN-PPTP Server.
3. Next to VPN-PPTP Server, check the Enable option to enable the PPTP server.
4. Next to Server virtual IP, enter the LAN IP address of your router.
Note: The LAN IP address of your router is automatically entered therefore, it is
recommended to leave this setting unchanged.
5. Enter the IP address range to assign to PPTP VPN clients.
Note: Please ensure that this range does not conflict with your DHCP server range. If you
have not changed your LAN IP settings or DHCP server range, then you can leave hese
settings at default. Router default DHCP server range: 192.168.10.101-192.168.10.199
•
IP Pool Start Address – Changes the starting address for the PPTP VPN server
range. (e.g. 192.168.10.10)
•
IP Pool End Address – Changes the last address for the PPTP VPN server range.
(e.g. 192.168.10.100)
6. Next to Authentication Protocol, check MS_CHAP and MS_CHAPv2.
© Copyright 2012 TRENDnet. All Rights Reserved.
7. Next to MPPE Encryption Mode, check the Enable option.
8. Next to Encryption Length, to ensure highest compatibility, check 40 bits, 56 bits, and
128 bits.
9. Under User Accounts next to ID 1, enter the User Name and Password used by PPTP
VPN clients to authenticate.
Note: The same account can be used by multiple PPTP VPN clients.
10. Click Save at the bottom of the page to save the changes.
Note: If you would like to discard the changes, click Undo before you click Save. Clicking
Refresh will reload the page. Clicking PPTP Client will bring you to the PPTP Client mode
configuration page.
Note: For the VPN client computer, you will require a third party PPTP VPN software to
be installed configured matching the PPTP VPN settings on your router. Typically, PPTP
VPN software is pre-installed with most operating systems. Please refer to the your
operating system User's Guide/Manual for configuring the VPN settings. See Appendix.
To view the status of connected PPTP VPN clients, check the Connection Status section.
When a PPTP VPN client is connected, they will be listed under Connection Status. You
can click Disconnect to disconnect the PPTP VPN client.
TW100-BRV214
20
Advertisement
Table of Contents
