Table of Contents
Advertisement
TRENDnet User's Guide
VPN Router A Configuration (Server Mode)
Configuration > Security Setting >VPN-L2TP Server
1. Log into your router management page (see "Access your router management page"
on
page
36).
2. Click on Configuration at the top of the page, click on Security Setting, and click on
VPN-L2TP Server.
3. Next to VPN-L2TP Server, check the Enable option to enable the L2TP server.
4. Next to Server virtual IP, enter the LAN IP address of your router.
Note: The LAN IP address of your router is automatically entered therefore, it is
recommended to leave this setting unchanged.
5. Enter the IP address range to assign to L2TP VPN clients.
© Copyright 2012 TRENDnet. All Rights Reserved.
Note: Please ensure that this range does not conflict with your DHCP server range. If you
have not changed your LAN IP settings or DHCP server range, then you can leave hese
settings at default. Router default DHCP server range: 192.168.10.101-192.168.10.199
•
IP Pool Start Address – Changes the starting address for the L2TP VPN server
range. (e.g. 192.168.10.10)
•
IP Pool End Address – Changes the last address for the L2TP VPN server range.
(e.g. 192.168.10.100)
6. Next to Authentication Protocol, check MS_CHAP and MS_CHAPv2.
7. Next to MPPE Encryption Mode, check the Enable option.
8. Next to Encryption Length, to ensure highest compatibility, check 40 bits, 56 bits, and
128 bits.
9. Under User Accounts next to ID 1, enter the User Name and Password used by L2TP
VPN clients to authenticate.
Note: The same account can be used by multiple L2TP VPN clients.
10. Click Save at the bottom of the page to save the changes.
Note: If you would like to discard the changes, click Undo before you click Save. Clicking
Refresh will reload the page. Clicking L2TP Client will bring you to the L2TP Client mode
configuration page.
TW100-BRV214
26
Advertisement
Table of Contents
