TRENDnet TW100-BRV214 User Manual page 19

TRENDnet User's Guide
Note: Generally speaking if the LAN IP address setting of the router is 192.168.X.1 /
255.255.255.0, then the IP network will be identified as 192.168.X.0, X being any number
from 0-254.
• Local Subnet – The local LAN IP subnet or network of your local VPN router.
(e.g. 192.168.100.0)
• Local Netmask – The local LAN subnet mask of your local VPN router.
(e.g. 255.255.255.0)
• Remote Subnet – The remote LAN IP subnet or network of your remote VPN
router.
(e.g. 192.168.10.0)
•
Remote Netmask – The remote LAN subnet mask of your remote VPN router.
(e.g. 255.255.255.0)
•
Remote Gateway – The remote WAN (Internet) IP address of your remote VPN
router. (e.g. 10.10.10.10) Note: If the remote router is using dynamic DNS, you
can enter domain for the remote gateway instead of the WAN IP address.
Based on the example, the network settings will be the following:
7. Next to Preshare Key, enter the preshared key for your IPsec tunnel.
Note: The preshared key entered must be the same as the preshared key configured in
VPN Router A.
Note: The preshared key can consist of alphanumeric characters (a,b,C,?,*, /,1,2, etc.)
© Copyright 2012 TRENDnet. All Rights Reserved.
8. Click the PFS Group drop-down list, and select Same as Phase 1.
9. Next to Dead Peer Detection (DPD), check the Enable option.
10. Next to IKE Proposal, check the Enable option. Next to ID 1, click the Encryption
drop-down list and select AES-128 and click the DH Group drop-down list and select
Group 2. Check the Enable option.
Note: The IKE proposal settings must match the setting configured in VPN Router A.
11. Next to IPsec Proposal, check the Enable option. Next to ID 1, click the Encryption
drop-down list and select AES-128. Check the Enable option.
Note: The IPsec proposal settings must match the setting configured in VPN Router A.
12. Click Save at the bottom of the page to save the changes.
Note: If you would like to discard the changes, click Undo before you click Save.
TW100-BRV214
16