Denon AVR-4810CI Owner's Manual page 39

Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
STEP6 Store
7
Select "Store" and
ENTER
then press .
Save the measuring
results.
b The save operation
takes about 30 seconds
to complete.
NOTE
During saving of measuring results, be sure not to turn off the
power.
8
When the screen
shown on the right
appears, unplug the
setup microphone
from the AVR-4810CI
SETUP MIC jack.
9
Select "Exit" and then press ENTER
Exiting the GUI Menu
n
MENU
Press while the GUI menu is displayed.
The GUI menu display disappears.
NOTE
After performing Audyssey Auto Setup, do not change the
speaker connections or subwoofer volume. In event of a change,
perform Audyssey Auto Setup again.

Main remote control unit
operation buttons
• If there is a disparity between the results and the connection status,
or if an error message is displayed, check the error message against
the errors listed in the "Error Messages" section (vpage 37) and
perform Audyssey Auto Setup again.
• If the result still differs from the actual connection status after
remeasurement or the error message still appears, it is possible
that the speakers are not connected properly. Turn the AVR-4810CI
off, check the speaker connections and repeat the measurement
process from the beginning. Turn the AVR-4810CI off, check the
speaker connections and repeat the measurement process from the
beginning.
•
If you change a speaker position or orientation, perform Audyssey
Auto Setup again to obtain optimal equalizer correction.
.
:Displaying the menu
Cancel the menu
:Moves the cursor
:Confirm the setting
(Up/Down/Left/Right)
:Return to previous menu