Media Sensor Adjustment - Datamax Mark II M-4206 Operator's Manual

3.3 Media Sensor Adjustment

The Media Sensor needs to be positioned so that the printer can detect the presence of media and the top-of-form (except
for continuous stock, where the TOF is set through the front panel.
To adjust:
With media loaded, as described in Section 3.2, grasp the Slide Tab and move the Sensor Eye Mark into position over
media according to the table below.
If loading media, return to the media loading instructions.
12
Media Sensor Selection and Adjustment
Media Type Sensor Eye Mark Position
Die-cut Near the middle of the label
Notched Centered over the notch
Reflective Centered over the black mark
Continuous Near the middle of the media
Sensing Required
Gap
Gap
Reflective
Continuous
M-Class