Downloading Firmware And Fonts - Datamax Mark II M-4206 Operator's Manual

6.8 Downloading Firmware and Fonts

The operating programs and fonts for the printer are stored in Flash memory on the Main PCB. When program updates
and/or new features are added, they can be downloaded to the printer as follows:
1. Identify the new version for your model of printer from the Datamax Web site at
download it onto your computer's hard drive or a floppy disk.
2. Ensure that the printer is connected to the host, (via parallel port only) and that the power is 'On.' Using the DOS
copy command enter:
copy filename.dlf lpt1/b
copy filename.zs lpt1/b
Note: Other programs (e.g., hyper-terminal and certain Windows
3. The light will flash during the download.
READY
4. Following a successful download, the
previous printer setup will not be affected unless substantial firmware data structure changes have occurred. Print a
Database Configuration Label to verify your new firmware version.
Following an unsuccessful download, the
reset' (both the
READY
remain operational. If the printer fails to reset, toggle the power 'Off' and 'On.'
Try re-sending the file to the printer. If the failure continues, check the following possible causes:
•
An invalid or corrupted file is being downloaded - Ensure the file being downloaded is correct and applicable
for your printer model.
•
Possible communications error - Check the cable connection between the host and printer and ensure that a
quality, shielded cable is used.
•
Possible Flash memory problem - Call for service.
88
(non-display printer firmware is .dlf extension)
(display printer firmware is .zs extension)
Light will illuminate then the printer will perform a 'cold reset.' The
STOP
ERROR
and lights will be on during power-up initialization). The original firmware will
STOP
www.datamaxcorp.com
®
Driver programs) may also be used to download this file.
Light will illuminate then the printer will perform a 'warm
and
M-Class