Datamax Mark II M-4206 Operator's Manual page 126

Configuration Using IP Discovery (DHCP, BootP, and RARP)
Once the Ethernet Print Sever has been installed and connected, p
printer's power switch 'On'.
DHCP, BootP, and RARP are server services that provide a method for assigning and maintaining IP addresses. The Print
Server obtains IP information from this service.
The factory default has IP Discovery enabled. The Print Server makes IP requests at power-up. If using this method of
discovery, after the connection is established print a Configuration Label (see below) from the printer to obtain the IP
Address and then use it to install your printer port and driver to complete your setup.
Note: Depending upon your server, you may have to wait a minute or two for the assigned IP Address to appear on
the Configuration Label.
To print a configuration label:
With the printer on, loaded with media (at least 4 inches
wide) and ribbon (if printing with thermal transfer media).
Press the button once, then use the
scroll to
'PRINT CONFIGURATION'
button again to print.
Once you have obtained the assigned IP from the configuration label you can then install the port and printer driver using
the Windows ® 'Add a Printer Wizard'. See section, Installing the Printer Driver and Port in this document.
116
FWD button
and press the
lug in the power cord and Ethernet cable then turn the
COMMUNICATIONS
PRINT CONTROL
SERIAL PORT A:
HEAT
BAUD RATE
10
9600
PRINT SPEED
PROTOCOL
8.0 in/sec
BOTH
FEED SPEED
PARITY
8.0 in/sec
NONE
REVERSE SPEED
DATA BITS
4.0 in/sec
8
ROW OFFSET
STOP BITS
00.00 inches
1
COLUMN OFFSET
SERIAL PORT B:
00.00 inches
NOT INSTALLED
PRESENT DISTANCE
0.00 inches PARALLEL PORT A:
CUSTOM ADJUSTMENTS:
PORT DIRECTION
DARKNESS UNI-DIRECTIONAL
32
USB PORT
CONTRAST
INSTALLED
32
NIC ADAPTER:
ROW ADJUST
MAC:00-0d-70-00-00-09
0 DOTS
COLUMN ADJUST IP ADDRESS
0 DOTS 168.24.12.192
PRESENT ADJUST SUBNET MASK
64 DOTS 255.255.255.255
GATEWAY
168.24.254.254
PRINTER OPTIONS
SNMPTRAP DESTINATION
MODULES
000.000.000.000
A: NOT INSTALLED
IP DISCOVERY
B: NOT INSTALLED
ENABLED
D: NOT INSTALLED
F: NOT INSTALLED
G: NOT INSTALLED HOST SETTINGS:
X: NOT INSTALLED
HOST TIMEOUT
Y: NOT INSTALLED
10 sec
Z: NOT INSTALLED
CONTROL CODES
PRESENT SENSOR:
STANDARD CODES
MODE
FEEDBACK CHARACTERS
DISABLED
DISABLED
RETRACT DELAY
0 X 10mS
Assigned IP
Address
M-Class