Media Settings - Datamax Mark II M-4206 Operator's Manual

5.1.2 Media Settings

MEDIA TYPE
DIRECT THERMAL
THERMAL TRANSFER
SENSOR TYPE
GAP
CONTINUOUS
REFLECTIVE
LABEL LENGTH
04.00in (0-99.99)
MAXIMUM LABEL LENGTH
16.00in (0-99.99)
PAPER OUT DISTANCE
00.25in (0-99.99)
LABEL WIDTH
203DPI > 04.26in (.75-4.26)
300DPI > 04.16in (.75-4.16)
RIBBON LOW DIAMETER ♦
1.38 in (1.00-2.00)
SENSOR CALIBRATION ♦
PERFORM CALIBRATION
ADVANCED ENTRY
SENSOR LEVELS
SENSOR GAIN
44
Selects the printing method.
For use with heat sensitive media.
For use with media requiring a ribbon to create an image.
Selects the top-of-form (TOF) sensing method for the media.
The printer recognizes the TOF by sensing gaps in the media.
No TOF sensing. The LABEL LENGTH setting determines the length.
The printer recognizes the TOF by sensing reflective (black) marks on the media.
When the Sensor Type is set to Continuous, this value is used to determine the TOF.
Sets the maximum length between TOF marks (gap or reflective). If this limit is
exceeded, a top of form fault is declared.
Sets the length of travel before an out of stock condition is declared.
Sets the maximum limit for the printable width. Objects extending beyond this limit
will be clipped off and not printed.
Sets the threshold for a low ribbon indication.
Adjusts the printer to sense your media.
The user follows steps to allow the printer to calculate the empty, gap (or mark), and
paper values to set the media sensor.
The user directly inputs the best values to adjust the media sensor.
Sets threshold values for the media sensor parameters. Manual entry for paper, gap
(or mark), and empty thresholds.
Observe A/D reading and set SENSOR GAIN. Adjusts the sensitivity of the sensor
for custom label stock.
M-Class