Media Sensor Adjustment - Datamax h-class h-8308p Operator's Manual

3.2 Media Sensor Adjustment

Position the Media Sensor for proper label detection:
A. Raise the Printhead Assembly. Note the Red Dot (see illustration below) that identifies
the location of the Media Sensor.
B. Grasp the Slide Tab to position the Red Dot according to the Media Type, as detailed
below.
C. Lower the Printhead Assembly then rotate the Printhead Latch completely clockwise.
D. If necessary, return to Media Loading to complete the setup process; otherwise, close
the cover. With READY displayed, press and hold the FEED Key until at least one gap (or
mark) advances; see Section 3.4.

If using REFLECTIVE or CONTINUOUS media, select the appropriate SENSOR TYPE;
see Section 3.4 Configuring Media and Ribbon Settings.
Media Sensor Adjustment
Media Type
Die-cut
Notched
Reflective
Continuous
Red Dot Position
Centered over a label
Centered over a notch
Centered over a black mark
Centered over the material
15