Datamax Mark II M-4206 Operator's Manual page 104

Displayed Message
!
HBQ!NPEF!
GBVMUZ!TFOTPS!
!
!
!
PVU!PG!TUPDL!
!
!
!
QPTJUJPO!GBVMU!
!
!
QSJOU!FOHJOF!GBVMU!
!
!
SBN!GBVMU!
94
Printer Fault Messages
Description
Consistently high sensor
readings were detected.
The printer can not detect
media.
Two possible causes:
(1) The printer was
powered-off or reset during
a ribbon, out of stock or
TOF fault; or (2) the printer
was unable to complete the
Media Calibration.
The printer has detected a
problem within the print
logic.
The system has detected a
RAM failure.
(continued)
Possible Solution(s)
Press any key to continue. Ensure that media was removed
from the media sensor during the appropriate calibration
steps; also ensure that no labels are stuck in the media
sensor. Retry the calibration. If the problem persists, call for
service.
Try the following:
1) Load media.
2) Ensure that the labels are passing through the Media
Sensor.
3) Readjust the Media Sensor over the TOF mark; see
Section 3.3.
4) If using media with large gaps, adjust the Paper Out
Distance; see Section 5.1.2.
5) Calibrate the printer; see Section 5.4.
Depending upon the cause:
(1) Press the FEED Key in an attempt to identify and then
clear the related fault condition; or (2) if necessary, calibrate
the printer; see Section 5.4.
Try cycling the printer power 'Off' and 'On'. If the fault
does not clear, call for service.
Try cycling the printer power 'Off' and 'On'. If the fault
does not clear, call for service.
M-Class