Datamax Mark II M-4206 Operator's Manual page 107

Warning Messages:
Warning Messages are displayed for a period of five seconds. If multiple warnings are detected, the display will reflect the
highest priority message.
Displayed Message
!
!
EPU!GBJMVSF!
!
!
HBQ!NPEF!
XBSOJOH!MPX!CBDLJOH!
!
!
!
HPPECZF!
!
!
!
IPTU!DIBOHFT!QFOEJOH!
!
!
!
MPX!WPMUBHF!
!
!
SUD!SBN!GBJMVSF!
!
!
!
JQ!EJTDPWFS!GBJMFE!
!
!
!
UFNQFSBUVSF!QBVTF!
M-Class
Printer Warning Messages
Description
The printer has detected
defective printhead elements.
The printer measured only a small
difference between the 'empty'
and 'gap' sensor readings.
Power has been removed and
shutdown is in progress.
The host has pending
configuration changes that will
not take effect until a 'host reset
command' is issued.
The printer has detected a low
operating voltage.
The printer was unable to save
settings in permanent memory.
The printer was unable to find a
DHCP server.
A high printhead temperature
has been detected.
Action(s)
Replace the printhead if the print quality becomes
unacceptable.
Transparent backing or notched media typically gives
this indication. In this case, there may be a slight delay in
the 'Out of Stock' indication, after the media supply is
emptied; no action is required.
The printer power switch was turned 'Off', the line fuse
has blown, or AC line voltage has been lost.
To save changes, send a host reset command (in DPL);
or to discard changes, perform a Soft Reset (see Section
6.7).
Possible low or fluctuating line voltage level. Try
moving the printer to another outlet. When more than
50% black is being printed, try reducing the Heat Value
or the size of the black image. If the condition persists,
call for service.
Possible faulty Main PCB. If the condition persists, call
for service.
This message does not effect the operation of the
printer and can be cleared from the display by pressing
the button. To stop this from reoccurring be
FEED
sure the menu item 'IP DISCOVERY' is set to
'DISABLED', see Section 5.1.6.
No action required. Printing will resume after the
printhead cools.
97